Secondary Wan Configuration in Nebero?

To add 2nd ISP to nebero, You must have two things :
1. Admin Access to Nebero Console.
2. ISP details that include WAN IP , Subnet Mask , Gateway , Primary DNS , Secondary DNS provided by your internet provider.

You can find netconfig option under nebero config. Click on netconfig option. You will find a scrren like this :

To add 2nd ISP you have to fill the IP details that has been provided by the internet service provider (ISP) very carefully and Add it. After saving the IPs it will take one or two minutes to save the network configuration. Let the settings save without doing anything.
After the settings has been updated we have to restart the server. And physically connect the ISP internet cable to the switch where first ISP has been already connected. When the server will come up after the reboot we can check it by looking at the green dot on the top right of the nebero console. If its coming green ISP has been added successfully.

Step after adding 2nd ISP to nebero is that we have to do the bandwidth seetings for that particular ISP line in Bandwidth option. Look into the picture :
Here we will click on Setting option. And select “WAN 2”.
If you have 2MBPS line please give assured and maximum incoming bandwidth as 2048 KBPS and outgoing should be also same or as provided by ISP.
There is also an option of Define Quality of service for previous protocol. In this you can set how much of total bandwidth you want to give to that particular service or protocol and on which priority. It is shown in percentage. For example : If you want to give total 60% of bandwidth to browsing internet then please select 60% for web. On save the settings the bandwidth settings will be saved and we have to restart the server . As soon as the server will come up ,we can further proceed to make bandwidth pools. That will be assigned to the groups.

Posted on March 1, 2017 at 10:55 am

Comments are closed

Categories:

The comments are closed.